Bowers-group Baty - Dial Depth Gauge Manuel d'utilisateur télécharger pdf

DIAL DEPTH GAUGE INSTRUCTIONS

For more information visit www.baty.co.uk precision measuring instruments

Dial Depth Gauge

Please carefully review these instructions to ensure proper and accurate use of your new Depth Gauge.

Operation

Zero Point Confirmation

• Setting zero for measurements 0-25mm. Place the depth base on a surface plate or flat surface. Loosen the bezel lock screw, adjust the dial

on the depth gauge to the "0" position and tighten the screw.

Measuring Procedure

• For measuring lengths greater than 25mm add the necessary amount of measuring rods for the depth required.

• To ensure correct measurements after adding additional rods, the dial depth gauge should be set against a master part or a setting master

1: Tolerance markers

2: Bezel lock screw

3: Measuring base

4: Plunger

5: Extension rods 0-150mm

6: Spline point

7: Needle point

Specification:

Indicator range: 0-25mm

Measuring range with extensions: 550mm

Graduations: 0.01mm

Zeroing the indicator

(without the extensions)

on a flat surface.

Installation of an

extension rod.

Zeroing the indicator

using an extension rod

and a setting master.

Dial Depth Gauge_172-01_baty 22/07/2010 13:55 Page 1

DIAL DEPTH GAUGE INSTRUCTIONSFor more information visit www.baty.co.uk precision measuring instrumentsDial Depth GaugePlease carefully review these i

Pas de commentaire

Bowers-group Baty - Dial Depth Gauge Manuel d'utilisateur